How To Handle The Non Tangent Fault After The Sewing Of The Round Head Keyhole Machine?

For round head keyhole machine

In handling, we should adhere to the principle of "seeing more and moving less." do not blindly adjust unnecessary parts, so as not to cause unnecessary trouble or other technical failures.

In the face of the failure of the round head keyhole machine after the end of sewing is not tangent, we believe that the following are the main points.

1. check whether the lower knife drive connecting rod on the bent frame has any action before stopping.

2. when sewing is finished, it is necessary to see if the cutting edge of the tangent cutter is good. If there is slight wear, the blade can be removed and grinded.

3. we also need to check.

Is the cutter tip worn and tangled below the tangent cutter when it is tangent?

If so, we will undo the cutters on the tangent, move the tangent knife slightly, then tighten the cutters.

4. after sewing, sometimes the tangent is sometimes not tangent. We also need to listen to the sound when the machine stops and see if the machine stops.

If parking is not in place, then there will be tangent sometimes tangent phenomenon, because not every parking time is not in place.

There are many reasons why parking is not in place. For example, the belt is too loose. For this problem, we think it has nothing to do with the length of the machine's placing time. The real fault is caused by the 3 phase lines of the power socket used at that time and the 3 phase lines which are used now.

On the right side of the pulley there is a friction disc into the oil and so on are all the direct reasons for parking is not in place.

5. in

After the end, sometimes the tangent line of the round head keyhole machine is not tangent.

Under normal circumstances, the problem of software setup is mainly due to the fact that there is no normal connection between the digitizer and the garment CAD, and the software parameters are not set up correctly. In fact, there is no problem in the hardware device itself. This problem often occurs when replacing the connecting clothing CAD. This situation rarely occurs. Of course, such a situation will not always be the last needle to jump the needle, so the time phase between the needle and hook line of the round head keyhole machine must be adjusted in place.